[Aaug] Delayed ring

[Bill Learning]

If you haven't got it yet

Set the gateway on the ata to the gateway on the DSL not the Router. It
will pass through correctly on the routers route table.  Nat has to be
on both the * server and the ATA, but don't put a NAT address in.  The
issue is that it is using the router route table rather then where it
should be on the Modem, but really in sip speak your are double natted.


BTW I wouldn't implement this on a Large scale, it would be nasty


Bill Learning
Oscar Wilde said: "Moderation is a fatal thing. Nothing succeeds like
excess."

-----Original Message-----
From: aaug-bounces at atlaug.com [mailto:aaug-bounces at atlaug.com] On Behalf
Of Christopher Fowler
Sent: Thursday, February 08, 2007 3:48 PM
To: ATLANTA * USERS GROUP
Subject: Re: [Aaug] Delayed ring

I see this in the PBX log:

Feb  8 15:44:43 NOTICE[2831] chan_sip.c: Peer '301' is now UNREACHABLE!
Last qualify: 69


On Thu, 2007-02-08 at 15:30 -0500, Christopher Fowler wrote:
> I've plugged my ATA into a Linksys 802.11B router.  The router is
> plugged into my home network.  So to make a call the ATA needs to go
out
> of 2 firewalls.  The Linksys and then my Linux routers.
> 
> When I call the DID line and dial 301 to get my extension I
immediately
> go into voice mail.  I get a message that "The person at extension 301
> is on the phone".  My ATA does not ring.  About 60(s) later after I've
> hung up it rings.  When I answer it I only hear a dial tone.  Trixbox
> panel is showing the phone on hook.  Maybe dual firewalls is causing
an
> issue?  
> 
> _______________________________________________
> Aaug mailing list
> Aaug at atlaug.com
> http://lists.atlaug.com/mailman/listinfo/aaug

_______________________________________________
Aaug mailing list
Aaug at atlaug.com
http://lists.atlaug.com/mailman/listinfo/aaug